Expand Configuration and Management Manual (G06.24+)

Configuring Multi-Line Paths
Expand Configuration and Management Manual—523347-008
14-11
ADD DEVICE Command
V6SRCIPADDR v6src_ipaddr
is a required modifier that specifies the IP address associated with the NonStop
TCP/IPv6 process used by this Expand-over-IP line-handler process. Determining
IP addresses is described in Step 1 (C): Select a Process and SUBNET for
NonStop TCP/IPv6 Use on page 8-13. The address must be specified by number
(for example, 31CA:B145:5489:1034:1784:B245:4029:1257). It is not validated and
need not be accessible. The default is
0000:0000:0000:0000:0000:0000:0000:0000.
Required Modifiers for Expand-Over-ATM Lines
ASSOCIATESUBDEV #IP
identifies the ATM service access point (SAP). The only currently supported ATM
SAP is #IP.
CALLTYPE_ATMSAP
indicates that the ATMSAP connection through the SLSA subsystem will be used.
Either CALLTYPE_ATMSAP, CALLTYPE_PVC, or CALLTYPE_SVC is required.
CALLTYPE_PVC
indicates that a permanent virtual circuit (PVC) connection will be used. Either
CALLTYPE_ATMSAP, CALLTYPE_PVC, or CALLTYPE_SVC is required.
CALLTYPE_SVC
indicates that a switched virtual circuit (SVC) connection will be used. Either
CALLTYPE_ATMSAP, CALLTYPE_PVC, or CALLTYPE_SVC is required.
LIFNAME lif_name
is the name of the ATMSAP connection that will be used. For example, LIF01.
Identifying LIF names is described in Configuring an Expand Line-Handler Process
That Uses ATMSAP on page 9-9.
This modifier is only applicable to Expand-over-ATM line-handler processes that
use ATMSAP connections.
PVCNAME pvc_name
is the name of the PVC connection that will be used. For example, PVC01.
Identifying PVC names is described in Configuring an Expand Line-Handler
Process That Uses a PVC on page 9-6.
This modifier is only applicable to Expand-over-ATM line-handler processes that
use PVC connections.