Expand Configuration and Management Manual (G06.24+)

Configuring Multi-Line Paths
Expand Configuration and Management Manual—523347-008
14-14
Configuration Example
Configuration Example
The following example shows a multi-line path with one direct-connect line and one
Expand-over-SNA line. Figure 14-2 illustrates the configuration of this example.
The following command examples show the WAN subsystem SCF commands used to
configure the multi-line path shown in Figure 14-2.
•
The following SCF ADD PROFILE command creates a profile for a path-logical
device named EXPPATH using the PEXPPATH profile:
-> ADD PROFILE $ZZWAN.#EXPPATH, FILE $SYSTEM.SYS01.PEXPPATH
•
The following SCF ADD PROFILE command creates a profile named MLHTER
that will be used by the direct-connect line in the multi-line path. MLHDIR is
created using the PEXQMSWN profile.
-> ADD PROFILE $ZZWAN.#MLHDIR, FILE $SYSTEM.SYS01.PEXQMSWN
•
The following SCF ADD PROFILE command creates a profile named MLHSNA
that will be used by the Expand-over-SNA line in the multi-line path. MLHSNA is
created using the PEXQMNAM profile.
-> ADD PROFILE $ZZWAN.#MLHSNA, FILE $SYSTEM.SYS01.PEXQMNAM
•
The following SCF ADD DEVICE command creates a path-logical device named
$PATH. Note that $PATH uses the EXPPATH profile created above.
-> ADD DEVICE $ZZWAN.#PATH, PROFILE EXPPATH, IOPOBJECT &
$SYSTEM.SYSTEM.LHOBJ, CPU 0, ALTCPU 1, TYPE (63,1), &
RSIZE 0, PATHTF 1, NEXTSYS 21, l4TIMEOUT 3000
Figure 14-2. Multi-Line Configuration Example
Note. The SWAN concentrator used by the SNAX/APN process $SNA1 is shown as a
transparent box because it is not configured in the following command example.
046CDT .CDD
$PATH
$LINE1
$LINE2
$SNA1
MULTI
MULTI
ASSOCIATEDEV
SWAN003A
SWANxxxxx