Expand Configuration and Management Manual (G06.24+)

Configuring Multi-Line Paths
Expand Configuration and Management Manual—523347-008
14-17
PEXQMSWN and PEXQMSAT Modifiers
L3WINDOW n
Default: 2
Units: Packets
Range: 1 through 15 (L3MOD128), 1 through 7 (L3MOD8)
This modifier specifies the number of packets that can be outstanding without an
acknowledgment from the network. You should set L3WINDOW to the largest possible
value.
PEXQMSWN and PEXQMSAT Modifiers
The disk file $SYSTEM.SYSnn.PEXQMSWN defines modifiers for direct-connect lines in
multi-line paths. The disk file $SYSTEM.SYSnn.PEXQMSAT defines modifiers for
satellite-connect lines in multi-line paths. Table 14-4 lists the default value and range of
values for each modifier in this profile, if applicable. For modifiers that are mutually
exclusive, a check mark (3) is shown in the “Default Value” column to indicate which
modifier is present in the profile.
Note. Some X.25 networks limit the size of L3WINDOW. Consult your vendor for more
information.
Table 14-4. PEXQMSWN and PEXQMSAT Modifiers (page 1 of 2)
Modifier Default Value Range of Values
CLOCKMODE_DCE 3
CLOCKMODE_DTE
CLOCKSPEED_600
CLOCKSPEED_1200
CLOCKSPEED_2400
CLOCKSPEED_4800
CLOCKSPEED_9600
CLOCKSPEED_19200 3
CLOCKSPEED_38400
CLOCKSPEED_56000
CLOCKSPEED_115200
DELAY 10 0 through 511
DOWNIFBADQUALITY_ON
DOWNIFBADQUALITY_OFF 3
FLAGFILL_OFF
FLAGFILL_ON 3
FRAMESIZE 132 64 through 2047
INTERFACE_RS232 3