Expand Configuration and Management Manual (G06.24+)

Configuring Multi-Line Paths
Expand Configuration and Management Manual—523347-008
14-19
PEXQMIP Modifiers
PEXQMIP Modifiers
The disk file $SYSTEM.SYSnn.PEXQMIP defines modifiers for Expand-over-IP lines in
multi-line paths. Table 14-6 lists the default value and range of values for each modifier
in this profile, if applicable. For modifiers that are mutually exclusive, a check mark (3)
is shown in the “Default Value” column to indicate which modifier is present in the
profile.
CONNECTTYPE_ACTIVEANDPASSIVE 3
CONNECTTYPE_PASSIVE
FRAMESIZE 132 64 through 2047
L2RETRIES 10 1 through 255
LINEPRIORITY 1 1 through 9
LINETF 0 0 through 186
MAXRECONNECTS 0 0 through 32767
RETRYPROBE 20 1 through 255
RXWINDOW 7 2 through 15
SPEED 0 0 or 1200 through 224000
SPEEDK NOT_SET 0 through 4,000,000,000
STARTUP_OFF 3
STARTUP_ON
TXWINDOW 7 2 through 61
1. This is required modifier. It has no default value.
Table 14-6. PEXQMIP Modifiers (page1of2)
Modifier Default Value Range of Values
AFTERMAXRETRIES_DOWN
AFTERMAXRETRIES_PASSIVE 3
ASSOCIATEDEV
1
None Any 8-character string
CONNECTTYPE_ACTIVEANDPASSIVE 3
CONNECTTYPE_PASSIVE
DESTIPADDR
2
0.0.0.1 Any 36-character string
DESTIPPORT
1
1024 0 through 65534
DOWNIFBADQUALITY_ON
DOWNIFBADQUALITY_OFF 3
EXTMEMSIZE 2048 0 through 32767
Table 14-5. PEXQMNAM Modifiers (page 2 of 2)
Modifier Default Value Range of Values