Expand Configuration and Management Manual (G06.24+)

Configuring Multi-Line Paths
Expand Configuration and Management Manual—523347-008
14-21
PEXQMATM Modifiers
PEXQMATM Modifiers
The disk file $SYSTEM.SYSnn.PEXQMATM defines modifiers for Expand-over-ATM
lines in multi-line paths. Table 14-6 lists the default value and range of values for each
modifier in this profile, if applicable. For modifiers that are mutually exclusive, a check
mark (3) is shown in the “Default Value” column to indicate which modifier is present in
the profile.
Table 14-7. PEXQMATM Modifiers
Modifier Default Value Range of Values
AFTERMAXRETRIES_DOWN OFF ON or OFF
AFTERMAXRETRIES_PASSIVE 3 ON or OFF
ASSOCIATEDEV
1
None Any 8-character string
CONNECTTYPE_ACTIVEANDPASSIVE 3 ON or OFF
ATMSEL
2
%H80 0 through %HFF
CALLTYPE_PVC
3
3
CALLTYPE_SVC
2
CONNECTTYPE_PASSIVE
DESTATMADDR
2
(ISONSAP:
%H00...)
Any valid ISO NSAP ATM
address
DOWNIFBADQUALITY_ON
DOWNIFBADQUALITY_OFF 3
FRAMESIZE 132 64 through 2047
L2RETRIES 20 1 through 255
LINEPRIORITY 1 1 through 9
LINETF 0 0 through 186
MAXRECONNECTS 0 0 through 32767
PVCNAME
3
None Any 8-character string
QUALITYTHRESHOLD 0 0 to 99
QUALITYTIMER 60 seconds 0 to 77600 (12hrs)
RXWINDOW 7 2 through 15
SPEED 0 0 or 1200 through 224000
SPEEDK NOT_SET 0 through 4,000,000,000
STARTUP_OFF 3
STARTUP_ON
TXWINDOW 7 2 through 25
1. This is a required modifier.
2. This modifier is required for Expand-over-ATM line-handler processes that use SVC connections.
3. This modifier is required for Expand-over-ATM line-handler processes that use PVC connections.