Expand Configuration and Management Manual (G06.24+)

Subsystem Control Facility (SCF) Commands
Expand Configuration and Management Manual—523347-008
15-12
Considerations
Considerations
•
You can alter several paths with a single ALTER command by specifying multiple
PATH objects using parentheses as follows:
-> PATH ( path-name , path-name [ , path-name ] ... )
Examples
The following SCF command changes the value of the path’s NEXTSYS attribute to
system 100 and the value of its TIMERINACTIVITY attribute to 9 minutes and
30 seconds:
-> ALTER PATH $PATH1, NEXTSYS 100, TIMERINACTIVITY 9:30.00
The following SCF command changes the value of the TIMERINACTIVITY attribute to
10 minutes for two different paths:
-> ALTER PATH ($PATH2,$PATH3), TIMERINACTIVITY 10:00.00
ALTER LINE Command
The ALTER LINE command is described below. The LINE object type takes the
following form:
LINE line-name attribute-spec [, attribute-spec ]...
where line-name is the device name of a line and attribute-spec is one of
the following attribute name and value combinations: