Expand Configuration and Management Manual (G06.24+)

Subsystem Control Facility (SCF) Commands
Expand Configuration and Management Manual—523347-008
15-16
ALTER LINE Command
The valid range for this attribute is 0 to 5:27.67 minutes. The default is 10.00
seconds.
DSRTIMER time
specifies the amount of time that the line-handler process should wait after a Data
Set Ready (DSR) signal from the modem has shut off before it returns a modem
status message. This attribute applies to ServerNet wide area network (SWAN)
concentrators only. The time interval is specified in the format described in Time
Values on page 15-6.
The valid range for this attribute is 1.0 seconds to 5:27.67 minutes. The default is
1.0 second.
IDLETIMEOUT time
specifies the time interval to wait after modem loss before timing out following the
loss of a Data Set Ready (DSR) signal from the modem. The time interval is
specified in the format described in Time Values on page 15-6.
This attribute applies only to intelligent modems. For lines attached to a ServerNet
wide area network (SWAN) concentrator, IDLETIMEOUT is used as the idle
transmit timer and idle receive timer for Layer 2 running on the communications
line interface processor (CLIP).
The valid range for this attribute is 0.50 seconds to 5:27.67 minutes. The default is
10 seconds.
RETRYPROBE integer
specifies the number of times the Expand-over-NAM, Expand-over-ServerNet, or
Expand-over-FOX line-handler process will retry its probe of the network access
method (NAM), or how many times the Expand-over-IP or Expand-over-ATM line-
handler process will retry the probe of the remote Expand-over-IP or Expand-over-
ATM line-handler process before declaring the network unavailable. A value of 0
indicates that timeouts are ignored and the connect state is maintained.
The valid range for this attribute is 1 to 255. The default values are as follows:
Expand-over-NAM lines: 20
Expand-over-ServerNet lines 10
Expand-over-FOX lines: 10
Expand-over-IP lines: 19
Expand-over-ATM lines: 19