Expand Configuration and Management Manual (G06.24+)

Subsystem Control Facility (SCF) Commands
Expand Configuration and Management Manual—523347-008
15-18
Considerations
The default values for this attribute are as follows:
TIMERRECONNECT time
specifies the time interval that the Expand-over-NAM, Expand-over-ATM, Expand-
over-IP, Expand-over-ServerNet, or Expand-over-FOX line-handler process will
wait for a connection request to succeed. The range does not include 0. The time
interval is specified in the format described in Time Values on page 15-6.
Expand line-handler processes on opposite ends of an X25AM line should use
different values for TIMERRECONNECT.
The valid range for this attribute is 30.00 through 32767 seconds for Expand-over-
IP and Expand-over-ATM lines and 0 through 32767 seconds for Expand-over-
NAM, Expand-over-ServerNet, and Expand-over-FOX lines.
The default value for this attribute is 30.00 seconds for Expand-over-NAM,
Expand-over-ATM lines, and Expand-over-IP lines, and 60.00 seconds for Expand-
over-ServerNet and Expand-over-FOX lines.
Considerations
You can alter several lines with a single ALTER command by specifying multiple LINE
objects using parentheses as follows:
-> LINE ( line-name , line-name [ , line-name ] ... )
Table 15-5 specifies the applicable ALTER LINE attributes for the different types of
line-handler processes.
Expand-over-SNA lines: 1 through 32767
Expand-over-ServerNet lines: 30 through 32767
Expand-over-FOX lines: 30 through 32767
Expand-over-IP lines: 1
Expand-over-ATM lines: 1
Expand-over-X.25 lines: 300
Expand-over-SNA lines: 300
Expand-over-ServerNet lines: 30
Expand-over-FOX lines: 30