Expand Configuration and Management Manual (G06.24+)

Subsystem Control Facility (SCF) Commands
Expand Configuration and Management Manual—523347-008
15-20
Examples
Examples
The following SCF command changes the value of the line’s L2TIMEOUT attribute to
10 seconds:
-> ALTER LINE $LINEX, L2TIMEOUT 10.00
The following SCF command disables the transmission of FLAGs when the line-
handler process $LHBIT is in the idle state:
-> ALTER LINE $LHBIT, FLAGFILL OFF
The following SCF command changes the value of the TIMERPROBE attribute for two
different lines:
-> ALTER LINE ($LHX251,$LHX252), TIMERPROBE 4:30.50
RETRYPROBE X X X X
RXWINDOW X X
SPEED X X X X X
SPEEDK X X X X X
SRCIPADDR X
SRCIPPORT X
TIMERBIND X X
TIMERINACTIVITY X X X
TIMERPROBE X X X X
TIMERRECONNECT X X X X
TXWINDOW X X X X X
V6DESTIPADDR X
V6SRCIPADDR X
Table 15-5. ALTER LINE Attributes (page 2 of 2)
Attribute
Direct-
and
Satellite-
Connect
Expand-
Over-
NAM
Expand-Over-
ServerNet, and
Expand-Over-FOX
Expand-
Over-IP
Expand-
Over-
ATM