Expand Configuration and Management Manual (G06.24+)

Subsystem Control Facility (SCF) Commands
Expand Configuration and Management Manual523347-008
15-21
ALTER PROCESS Command
ALTER PROCESS Command
The ALTER PROCESS command changes the values of the attributes of the network
control process ($NCP). This command changes only the specified attributes of $NCP.
ALTER PROCESS is a sensitive command.
The ALTER PROCESS command for $NCP has the following syntax:
where attribute-spec for the PROCESS object type for $NCP has the following
attribute name and value combination:
Table 15-6 lists the $NCP attributes that have corresponding profile modifiers.
For detailed information about the $NCP attributes that have corresponding profile
modifiers, refer to the description of the corresponding profile modifier in Section 6,
Configuring the Network Control Process.
$NCP attributes that do not have corresponding profile modifiers are as follows:
AUTOREBAL { ON | OFF }
enables (ON) or disables (OFF) automatic rebalancing of the multi-CPU paths on
the system. The time at which automatic rebalancing will occur is determined by
the AUTOREBALTIME attribute. The default value is ON.
ALTER PROCESS $NCP attribute-spec [ attribute-spec ] ...
[ ABORTTIMER time ]
[ AUTOREBAL { ON | OFF } ]
[ AUTOREBALTIME { time | ( time, start-time ) } ]
[ CONNECTTIME time ]
[ MAXCONNECTS integer ]
[ MAXTIMEOUTS integer ]
[ NETWORKDIAMETER integer ]
[ MSG43 { ON | OFF } ]
[ MSG46 { ON | OFF } ]
[ MSG48 { ON | OFF } ]
[ MSG49 { ON | OFF } ]
Table 15-6. ALTER PROCESS Attributes and Corresponding Profile Modifiers
SCF Attribute Profile Modifier
ABORTTIMER ABORTTIMER
n
CONNECTTIME CONNECTTIME n
MAXCONNECTS MAXCONNECTS n
MAXTIMEOUTS MAXTIMEOUTS n
NETWORKDIAMETER NETWORKDIAMETER n