Expand Configuration and Management Manual (G06.24+)

Subsystem Control Facility (SCF) Commands

Expand Configuration and Management Manual—523347-008

15-22

ALTER PROCESS Command

AUTOREBALTIME time | ( time, start-time )

determines when automatic rebalancing of multi-CPU paths on the system will

occur.

When time is specified, rebalancing will occur periodically at the time interval

specified starting after the command is executed.

When (time, start-time) is specified, rebalancing will occur periodically at the

time interval specified starting at the time of day specified in start-time. The

time of day must be specified using a 24-hour clock and the local time of the

system on which $NCP resides.

The format of time interval (time) and time of day (start-time) is as follows:

[DDD/]HH:MM:SS

where

[DDD/]

specifies the number of days and is an integer in the range 0 to 999. When

[DDD/] is specified in the starting time (start-time), it represents the

number of days that the specified time of day will be skipped before the first

automatic rebalancing will occur.

specifies the hours and is an integer in the range 0 to 23.

specifies the minutes and is an integer in the range 0 to 59.

specifies seconds and is an integer in the range 0 to 59.

The default time interval is 1/0:0:0 (24 hours) and the default start time is 0:0:0

(midnight). The minimum time interval (time) is 15 minutes.

MSG43 { ON | OFF }

enables (ON) or disables (OFF) the reporting of event message 43 to the Event

Message Service (EMS) collector, $0. Event message 43 is equivalent to console

message 43. This is a critical message. It means that the connection to the

indicated system has been lost. The default value is OFF.

MSG46 { ON | OFF }

enables (ON) or disables (OFF) the reporting of event message 46 to the EMS

collector, $0. Event message 46 is equivalent to console message 46. This is not a

critical message. It means a connection has been made with the indicated remote

system. The default value is OFF.