Expand Configuration and Management Manual (G06.24+)

Subsystem Control Facility (SCF) Commands
Expand Configuration and Management Manual—523347-008
15-26
INFO PATH Command
Compress
shows whether Layer 4 data compression is enabled (ON) or disabled (OFF).
Nextsys
is the system number of the neighbor system on this path.
OSspace
displays the maximum buffer size (in words) for storing out-of-sequence (OOS)
packets.
Please refer to the note under OSSPACE n on page 17-17 that explains why the
recommended setting for OSSPACE is to not specify it, but to let the default be
used.
OStimeout
reports the amount of time, in one-hundredth of a second increments, that OOS
packets are held before they are discarded. For example, an OStimeout value of
300 is equal to 5 minutes.
L4Retries
specifies the number of times the line-handler process will try an end-to-end (Layer
4) request before reporting an error.
PathTF
is the path time factor. PATHTF has a range of 0 to 186, with a default of 0 (unset).
If you set PATHTF, it overrides any other parameter (RSIZE, SPEED, SPEEDK, or
LINETF) in calculating the time factor for the path. When PATHTF is set for a multi-
line path, the line state and number of lines in the path are ignored and the
PATHTF setting is a constant value assigned to the time factor for the path. If
PATHTF is left unset (a zero value), this parameter is not used in setting the time
factor.
Example 15-2. INFO PATH, DETAIL Command
-> INFO PATH $LHPATH, DETAIL
EXPAND Detailed Info PATH $LHPATH
*Compress.... ON *Nextsys........ #255 *OSspace..... 32767
*OStimeout... 0:00:03.00 *L4Retries...... 3 *PathTF.. 1
*L4Timeout... 0:00:20.00 *L4SendWindow... 254 TimeFactor 1
*L4ExtPackets ON *L4CongCtrl..... ON *Superpath... ON
Local Remote Negotiated Maximum
*PathBlockBytes 0 0 0 9180
*PathPacketBytes 1024 0 0 9180