Expand Configuration and Management Manual (G06.24+)

Subsystem Control Facility (SCF) Commands
Expand Configuration and Management Manual523347-008
15-32
Direct-Connect and Satellite-Connect Line-Handler
Processes
in the QualityThreshold before taking the action specified in the parameter
DownIfBadQuality.
TxWindow
reports the number of Expand packets that the line-handler process can send
before receiving a reply.
Address
specifies the Layer 2 primary and secondary addresses. Addresses are system
numbers.
Autoload
reports whether or not the automatic downloading of microcode to the
communications line interface processor (CLIP) is enabled or disabled. In the
example above, it is enabled (ON). If AUTOLOAD is ON, the microcode is
downloaded to the CLIP whenever the CLIP restarts.
LineBufSize
reports the size of the Expand line buffer.
Dsrtimer
specifies the time interval, in one-hundredth of a second increments, that the
communications line interface processor (CLIP) will wait for the Data Set Ready
(DSR) signal from the modem before informing the Communications Access
Process (CAP) of no detection.
Idletimeout
reports the time interval to wait after modem loss before timing out.
Interface
reports the electrical interface (RS-232 or RS-449) used.
Readbuffers
shows the number of read frame buffers in the line buffer. Expand automatically
adjusts Readbuffers to be TXWINDOW + 4 for lines that use the SWAN
concentrator.
L2Retries
specifies the number of times that the line-handler process will retry a request at
Layer 2 before reporting an error.