Expand Configuration and Management Manual (G06.24+)

Subsystem Control Facility (SCF) Commands
Expand Configuration and Management Manual—523347-008
15-33
Direct-Connect and Satellite-Connect Line-Handler
Processes
DRtimeout
specifies the time interval that the line-handler process Communications Access
Process (CAP) will wait for a response to a request it has sent to the
communications line interface processor (CLIP).
CLBIdleTimer
specifies the time interval between communications line interface processor (CLIP)
status probes.
Threshold
specifies the number of information frames that must be sent and received before
line quality is calculated.
L2Timeout
specifies the length of time, in one-hundredth of a second increments, that the line-
handler process will wait for a response to request at Layer 2 before retrying.
Protocolid
reports the communications line interface processor (CLIP) protocol identifier.
Flagfill
specifies whether a specific bit pattern called FLAG will be set during the idle
period for a line. A value of OFF causes the ServerNet wide area network (SWAN)
concentrator to keep an idle line in the MARK HOLD instead of the IDLE FLAGS
state. Some modems and data circuit-terminating equipment (DCE) require the idle
line state to be configured with FLAGFILL ON.
ClockMode
indicates whether the clocking signals for the communications line interface
processor (CLIP) clock are enabled (DTE) or disabled (DCE).
ClockSpeed
reports the clock rate (in bits per second) when ClockMode is DTE.
CLBdwnloadRetries
specifies the maximum number of times that the line-handler process will try to
download a communications line interface processor (CLIP).
CLBdwnloadTimr
specifies the time interval that the line-handler process will wait for successful
completion of a communications line interface processor (CLIP) download
operation.