Expand Configuration and Management Manual (G06.24+)

Subsystem Control Facility (SCF) Commands
Expand Configuration and Management Manual—523347-008
15-34
Expand-Over-IP Line-Handler Processes
Program
reports the file name of the communications line interface processor (CLIP)
program that will be downloaded.
LineTF
is the line time factor. LINETF has a range of 0 to 186, with a default of 0 (unset). If
you set LINETF, it overrides the RSIZE, SPEED, or SPEEDK parameters in
calculating the time factor for the line (PATHTF overrides all parameters, including
LINETF). If LINETF is left unset (a zero value), this parameter is not used in setting
the time factor.
Expand-Over-IP Line-Handler Processes
For Expand-over-IP line-handler processes, the display for a LINE object without the
DETAIL option has the format as shown in Example 15-5. The asterisk (*) indicates an
alterable attribute.
Name
is the device name of the line.
Delay
is the expected line time required for a bit to arrive at the other end of the line. This
value is considered in multi-line paths to help packets arrive in the correct order at
the destination system.
Framesize
specifies the maximum size frame that can be sent in the network; smaller frames
may be sent. The Expand subsystem also uses the FRAMESIZE modifier value to
calculate the packet size and determine the size of the frame buffers. If the default
FRAMESIZE modifier value is used, the packet size is 132 words.
Associatedev
reports the name of the NonStop TCP/IP, TCPSAM, or TCP6SAM process
associated with the Expand-over-IP line-handler process.
Maxreconnects
reports the maximum number of times the Expand-over-IP line-handler process will
try to connect to the remote system.
Example 15-5. INFO LINE Command, Expand-Over-IP Line-Handler Processes
-> INFO LINE $IPTAH0
Name Delay Framesize *Associatedev *Maxreconnects *Aftermaxretries
$IPTAH0 0:00:00.10 132 $ZTC02 3 PASSIVE