Expand Configuration and Management Manual (G06.24+)

Subsystem Control Facility (SCF) Commands
Expand Configuration and Management Manual—523347-008
15-36
Expand-Over-IP Line-Handler Processes
L2Protocol
is the Layer 2 protocol process associated with the Expand-over-IP line-handler
process.
TimeFactor
reports the current time factor for this line. See Routing and Time Factors on
page 18-22 for a discussion on time factors, including how to calculate them.
SpeedK
calculates the time factor of the line for the Expand routing algorithm. A value of
NOT_SET means that this parameter was not set. See SPEEDK n on page 17-23
for a discussion of SPEEDK.
Framesize
specifies the maximum size frame that can be sent in the network; smaller frames
may be sent. The Expand subsystem also uses the FRAMESIZE modifier to
calculate the packet size and determine the size of the frame buffers. If the default
FRAMESIZE modifier value is used, the packet size is 132 words.
Rsize
specifies the time factor of the line for the Expand routing algorithm. RSIZE can be
0 if the time factor is set using some other modifier.
Speed
calculates the time factor of the line for the Expand routing algorithm.
Example 15-7. INFO LINE, DETAIL Command, Expand-Over-IP Line-Handler
Processes for IPv6 Lines
-> INFO LINE $IPTAH0, DETAIL
EXPAND Detailed Info LINE $IPTAH0 (LDEV 175)
L2Protocol Net^Ip TimeFactor...... 3 *SpeedK........ NOT_SET
Framesize....... 132 -Rsize........... 3 -Speed........
*LinePriority.... 1 StartUp......... OFF Delay......... 0:00:00.10
*DownIfBadQuality OFF *QualityThreshold 96 *QualityTimer.. 0:01:00.00
*Txwindow........ 7 *Maxreconnects... 0 *AfterMaxRetries PASSIVE
*Timerreconnect 0:00:30.00 *Retryprobe...... 19 *Timerprobe.... 0:00:01.00
*Associatedev.... $ZTC02 *LineTf.......... 0 *Timerinactivity 0:00:00.00
*IPVer IPV6
*DestIpAddr 16.107.190.66 *DestIpPort......11171
*SrcIpAddr 16.107.188.67 *SrcIpPort.......11171
*V6DestIpAddr fe80::a00:8eff:fe00:897b
*V6SrcIpAddr fe80::a00:8eff:fe00:897a