Expand Configuration and Management Manual (G06.24+)

Subsystem Control Facility (SCF) Commands
Expand Configuration and Management Manual—523347-008
15-38
Expand-Over-IP Line-Handler Processes
Timerreconnect
is the time interval the Expand-over-IP line-handler process will wait for a
successful connection.
Retryprobe
is the number of times the Expand-over-IP line-handler process will retry the probe
of the remote Expand-over-IP line-handler process before concluding that the
network is unavailable.
Timerprobe
is the time interval that the Expand-over-IP line-handler process will wait to probe
the remote Expand-over-IP line-handler process.
Associatedev
reports the name of the NonStop TCP/IP, TCPSAM, or TCP6SAM process
associated with the Expand-over-IP line-handler process.
LineTF
is the line time factor. LINETF has a range of 0 to 186, with a default of 0 (unset). If
you set LINETF, it overrides the RSIZE, SPEED, or SPEEDK parameters in
calculating the time factor for the line (PATHTF overrides all parameters, including
LINETF). If LINETF is left unset (a zero value), this parameter is not used in setting
the time factor.
Timerinactivity
is the time interval the Expand-over-IP line-handler process will wait while the line
is inactive before it requests the disconnection of the network service. The default
value is 0 (no timer).
IPVer
specifies whether the destination and source addresses are IPv4 or IPv6. The
default is IPv4.
DestIpAddr
is the TCP/IP address used by the remote Expand-over-IP line-handler process. It
is used only if the IPVER is IPv4.
DestIpPort
is the port number used by the remote Expand-over-IP line-handler process. It is
used for both IPVER IPv4 and IPv6.