Expand Configuration and Management Manual (G06.24+)

Subsystem Control Facility (SCF) Commands
Expand Configuration and Management Manual—523347-008
15-39
Expand-Over-ATM Line-Handler Processes
SrcIpAddr
is the TCP/IP address used by the local Expand-over-IP line-handler process. It is
used only if the IPVER is IPv4.
SrcIpPort
is the port number used by the local Expand-over-IP line-handler process. It is
used for both IPVER IPv4 and IPv6.
V6DestIpAddr
is the destination NonStop TCP/IPv6 address used by the remote Expand-over-IP
line-handler process. It is used only if the IPVER is IPv6.
V6SrcIpAddr
is the source NonStop TCP/IPv6 address used by the local Expand-over-IP line-
handler process. It is used only if the IPVER is IPv6.
Expand-Over-ATM Line-Handler Processes
For Expand-over-ATM line-handler processes, the display for a LINE object without the
DETAIL option has the format as shown in Example 15-8. The asterisk (*) indicates an
alterable attribute.
Name
is the device name of the line.
Delay
is the expected line time required for a bit to arrive at the other end of the line. This
value is considered in multi-line paths to help packets arrive at the destination
system in the correct order.
Framesize
specifies the maximum size frame that can be sent in the network; smaller frames
may be sent. The Expand subsystem also uses the FRAMESIZE modifier to
calculate the packet size and determine the size of the frame buffers. If the default
FRAMESIZE modifier value is used, the packet size is 132 words.
Example 15-8. INFO LINE Command, Expand-Over-ATM Line-Handler Processes
-> INFO LINE $AMLBA0
EXPAND Info LINE
Name Delay Framesize *Associatedev *Associatesubdev
$AMLBA0 0:00:00.10 132 $AM2 #IP