Expand Configuration and Management Manual (G06.24+)

Subsystem Control Facility (SCF) Commands
Expand Configuration and Management Manual—523347-008
15-41
Expand-Over-ATM Line-Handler Processes
Rsize
specifies the time factor of the line for the Expand routing algorithm. RSIZE can be
0 if the time factor is set using some other modifier.
Speed
calculates the time factor of the line for the Expand routing algorithm.
LinePriority
This can be set in the range 1 to 9. The default is 1. The higher the number, the
lower priority to use that line. If lines have equal priority, the relative line speeds
and transmission delays are used to select the next line.
Startup
indicates whether the line will be enabled (ON) or disabled (OFF) after a system
load.
Delay
is the expected line time required for a bit to arrive at the other end of the line. This
value is considered in multi-line paths to help packets arrive at the destination
system in the correct order.
DownIfBadQuality
This can be set either ON or OFF. The default is OFF. If set to ON and the
QualityTimer expires, an EMS message is generated and the line is aborted. If set
to OFF and the QualityTimer expires, an EMS message is generated and the line
is not aborted.
QualityThreshold
This can be set in the range 0 to 99. The default is 0. If the line reports quality
lower than this percentage value, a timer is started.
QualityTimer
This can be set in the range of 0 through 12 hours. The default is 0. Specifies the
time interval to wait after the line quality drops below the threshold value specified
in the QualityThreshold before taking the action specified in the parameter
DownIfBadQuality.
Txwindow
is the number of Expand packets that the Expand-over-ATM line-handler process
can send before receiving a reply.