Expand Configuration and Management Manual (G06.24+)

Subsystem Control Facility (SCF) Commands
Expand Configuration and Management Manual—523347-008
15-45
Expand-Over-NAM, Expand-Over-ServerNet, and
Expand-Over-FOX Line-Handler Processes
SpeedK
calculates the time factor of the line for the Expand routing algorithm. A value of
NOT_SET means that this parameter was not set. See SPEEDK n on page 17-23
for a discussion of SPEEDK.
Framesize
specifies the maximum size frame that can be sent in the network; smaller frames
may be sent. The Expand subsystem also uses the FRAMESIZE modifier value to
calculate the packet size. The FRAMESIZE modifier value also determines the size
of the frame buffers.
Rsize
displays the time factor of the line for the Expand routing algorithm. RSIZE can be
0 if the time factor is set using some other modifier.
Speed
calculates the time factor of the line for the Expand routing algorithm.
LinePriority
can be set in the range 1 to 9. The default is 1. The higher the number, the lower
priority to use that line. If lines have equal priority, the relative line speeds and
transmission delays are used to select the next line.
StartUp
shows that the line will be disabled (OFF) or enabled (ON) after a system load.
Delay
reports the time interval between transmissions. See Time Values on page 15-6 for
a description of the time interval format.
Rxwindow
specifies the number of packets that the input-output process (IOP) will send to the
line-handler process before the line-handler process must send a reply.
Timerbind
specifies the time interval that the Expand-over-NAM, Expand-over-ServerNet, or
Expand-over-FOX line-handler process will wait for a completion of its bind request
to the NAM process. See Time Values on page 15-6 for a description of the time
interval format