Expand Configuration and Management Manual (G06.24+)

Subsystem Control Facility (SCF) Commands
Expand Configuration and Management Manual—523347-008
15-48
INFO PROCESS Command
The INFO PROCESS command has the following syntax:
/OUT file-spec /
causes any SCF output generated by the command to be directed to the specified
file.
CONNECTS
displays the systems that are connected or connecting, and only the entry for
which the connection is established. If the path is a superpath, the CONNECTS
option displays all of the paths in the superpath.
LINESET
displays the status of a selected path and the status of the started lines that make
up that path.
NETMAP
displays the status of the network as seen from a specific system.
PATHSET
displays the NCP pathmap information, similar to the LINESET option but in a
different format. This new format displays both the line-handler LDEV and name,
as well as the other information already in the LINESET option.
SUPERPATH
displays the paths comprising each multi-CPU path on the system.
RPT system-name
displays the reverse pairing table (RPT) for the specified multi-CPU path.
INFO [ /OUT file-spec / ] PROCESS $NCP
[ , { CONNECTS | LINESET | NETMAP | PATHSET | SUPERPATH |
SYSTEMS | RPT system-name } ]
[ , AT { system-list | * } ]
[ , TO { system-list | * } ]
[ , DETAIL ]
Note. The LINESET option only displays information on active lines (lines that have been
started at least once after a system load). To see information on all configured lines, use the
SCF command LISTDEV TYPE 63.