Expand Configuration and Management Manual (G06.24+)

Subsystem Control Facility (SCF) Commands
Expand Configuration and Management Manual—523347-008
15-49
INFO PROCESS Command
SYSTEMS
displays all known systems. If no connection is established, the SYSTEMS option
displays an infinite time factor and hop count. The SYSTEMS option is similar to
the CONNECTS option, except that the CONNECTS option displays only the
systems connected.
AT { system-list | * }
where
system-list
is ( [ sys-a [ , sys-b [ , sys-c [ , .... ] ] ] ] ).
sys-a
is {\system-name | system-number }.
sys-b
is {\system-name | system-number }.
sys-c
is {\system-name | system-number }.
If the NETMAP, SUPERPATH, or RPT option is chosen, only one system can be
specified.
If the SUPERPATH option is chosen, the display lists the multi-CPU paths on a
remote node.
If the RPT option is chosen, the display lists the reverse pairing table (RPT) on a
remote node.
If the AT option is omitted, the SCF target system is assumed.
If AT * is specified and the LINESET or PATHSET option is chosen, the display is
the status of a selected path and the lines that make up the path of all accessible
nodes in the network.
TO { system-list | * }
where
system-list
is ( [ sys-a [ , sys-b [ , sys-c [ , .... ]]]] ).
Note. If none of the formatting options (LINESET, NETMAP, PATHSET, SUPERPATH, and
RPT) are specified, local $NCP information is displayed.