Expand Configuration and Management Manual (G06.24+)

Subsystem Control Facility (SCF) Commands
Expand Configuration and Management Manual—523347-008
15-50
INFO PROCESS Command
sys-a
is {\system-name | system-number }.
sys-b
is {\system-name | system-number }.
sys-c
is {\system-name | system-number }.
The TO option is valid only when NETMAP has been selected. It causes the
display of the network status as viewed from the system specified in the AT option
through the system specified in the TO option.
If the TO option is omitted and the NETMAP option is selected, the status of the
whole network as seen from the system specified in the AT option is displayed. If
this option is specified as TO * and the NETMAP option is selected, the status of
the whole network as seen from the system specified in the AT option is displayed.
DETAIL
causes detailed information of $NCP attributes to be displayed. If not specified,
only one line of $NCP attribute information is displayed.
The display for the INFO PROCESS $NCP command without the DETAIL option has
the format as shown in Example 15-12. The asterisk (*) denotes an alterable attribute.
Name
is the device name of the network control process ($NCP).
AutomaticMaptimer
reports the current map-propagation rate in effect in the Expand network.
Framesize
reports the network-wide frame size (in words) used by all line-handler processes
in the Expand network. $NCP uses this value to calculate the number of entries in
the distance vector (DV) or map packet (that is, the maximum size of the map
packet).
Example 15-12. INFO PROCESS $NCP Command
-> INFO PROCESS $NCP
EXPAND Info PROCESS $NCP AT \NODEA (151)
Name AutomaticMaptimer Framesize *Maxtimeouts *Maxconnects
$NCP ON #132 3 5