Expand Configuration and Management Manual (G06.24+)

Subsystem Control Facility (SCF) Commands
Expand Configuration and Management Manual—523347-008
15-51
INFO PROCESS Command
Maxtimeouts
defines the maximum number of retry attempts allowed to establish a connection.
Maxconnects
specifies the maximum number of times $NCP will attempt a connection (CONN)
request.
The display for the INFO PROCESS $NCP command with the DETAIL option has the
format as shown in Example 15-13. The asterisk (*) denotes an alterable attribute.
Max System Number
reports the highest valid system number allowed within the network.
Aborttimer
specifies the length of time $NCP will wait before aborting requests destined for a
remote system to which an alternate path has not yet been identified.
ABORTTIMER must be set to the same value on all systems in the network.
Algorithm
identifies the $NCP routing algorithm to be used. In this case, it is modified split
horizon (MSH).
AutomaticMaptimer
specifies a distance vector (DV) propagation rate of 8 seconds multiplied by the
time factor (TF) for the path (ON), or an algorithm with a 5-minute propagation
interval (OFF).
Example 15-13. INFO PROCESS $NCP, DETAIL Command
-> INFO PROCESS $NCP, DETAIL
EXPAND Detailed Info PROCESS $NCP AT \NODEA (117)
Max System Number.. 254 *Aborttimer......... 0:00:40.00
Algorithm.......... MODIFIEDSPLIT AutomaticMaptimer.. ON
*Connecttime........ 0:00:00.00 Framesize.......... 132
*Maxtimeouts........ 3 *Maxconnects........ 5
*NetworkDiameter.... 15 Type............... (62,0)
*Message 43......... OFF Message 44......... ON
Message 45......... ON *Message 46......... OFF
Message 47......... ON *Message 48......... OFF
*Message 49......... OFF *AutoRebal.......... OFF
Next Rebalance Time 0/00:00:00 *AutoRebalTime...... 1/00:00:00
Trace File Name.... \NODEA.$SYSTEM.SYSTEM.NCPLOG