Expand Configuration and Management Manual (G06.24+)

Subsystem Control Facility (SCF) Commands
Expand Configuration and Management Manual—523347-008
15-57
LINESET Option
TF
indicates time factors in this display. To use old time-factor values, use the
command INFO PROCESS $NCP, OLDLINESET.
If you are using the OLDLINESET option on a G06.20 node, the command INFO
PROCESS $NCP, LINESET, AT \remote, where \remote is a G06.19 node,
displays super time factor information, and the command INFO PROCESS $NCP,
OLDLINESET, AT \remote displays non-super time factor information.
PID
is the process ID.
LINE
indicates the device name of a line.
LDEV
indicates the logical device (LDEV) number associated with each line logical
device.
STATUS
indicates the status of the line: ready or not ready.
FileErr#
shows the most recent file system error number, if any, associated with each line.
Note. If a line handler becomes hung for more than 60 seconds such that the NCP cannot
communicate with it, the LINESET option shows “NOT READY (201)” in the STATUS field.
If this occurs, you must abort and restart the line handler to put the path back into use. The
linehandler has been observed to only get into this situation during extremely heavy FOX
pass-through traffic.