Expand Configuration and Management Manual (G06.24+)

Subsystem Control Facility (SCF) Commands
Expand Configuration and Management Manual—523347-008
15-61
PATHSET Option
PATHSET Option
The PATHSET option displays the NCP pathmap information, similar to the LINESET
option but in a different format. This format displays both the line-handler LDEV and
name, as well as the other information already in the LINESET option.
Ls
indicates each communications path (LINESET) directly connected to the selected
system. If the path is a multi-line path, the logical device (LDEV) number
associated with each line logical device is also displayed. An “S” next to a
LINESET indicates that it is a member of a multi-CPU path.
Neighbor(node)
indicates the neighbor node that data is transmitted to over the path.
TF
reports the current time factor for this line. See Routing and Time Factors on
page 18-22 for a discussion on time factors, including how to calculate them.
Cpu, Pin
uniquely identifies a process. This number consists of the processor number and
the process identification number (PIN).
Line
indicates the line number.
Example 15-17. INFO PROCESS $NCP Command, PATHSET Option
-> INFO PROCESS $NCP, PATHSET
EXPAND Info PROCESS $NCP ,PATHSETS
PATHSETS AT \NODEA (117) #LINESETS=7 TIME: FEB 24,2003 13:55:18
Ls Neighbor(node) TF (Cpu,Pin) Line Name (LDEV) Status FileErr#
1 S \NODEB (082) 1 ( 1, 334) $SPATH1 ( 122)
1 $SPATH1 ( 122) READY
2 S \NODEB (082) 1 ( 0, 333) $SPATH0 ( 123)
1 $SPATH0 ( 123) READY
3 S \NODEB (082) 1 ( 0, 332) $SPATH2 ( 121)
1 $SPATH2 ( 121) READY
4 \NODEB (082) ----- (--,-----) $IPSTAH ( 131)
1 $IPSTAH ( 131) NOT READY (066)
5 \NODEB (082) 3 ( 2, 271) $IPTAH1 ( 125)
1 $IPTAH1 ( 125) READY
6 \NODEF (247) ----- (--,-----) $IPSFIJ ( 132)
1 $IPSFIJ ( 132) NOT READY (066)
7 \NODEF (247) ----- (--,-----) $IPFIJP ( 175)
1 $IPFIJ02 ( 212) NOT READY (066)
2 $IPFIJ03 ( 254) NOT READY (066)
3 $IPFIJ00 ( 256) NOT READY (066)
4 $IPFIJ01 ( 259) NOT READY (066)