Expand Configuration and Management Manual (G06.24+)

Subsystem Control Facility (SCF) Commands
Expand Configuration and Management Manual—523347-008
15-85
Expand-Over-ServerNet, Expand-Over FOX,
Expand-Over-X.25, and Expand-Over-SNA Line-
Sampletime
is the last time the statistics were collected.
Bind
indicates the line handler bind to an associate device (such as $ZZFOX, $ZZSCL,
or $X25AM).
Aconn
indicates the number of connects while in active mode.
Pconn
indicates the number of connects while in passive mode. An active connect
message is expected as the reply.
Query
indicates that the Expand line-handler process is connected to the remote
(destination) Expand line-handler process, but no data has been received within
the inactivity interval (SCF TIMERPROBE attribute). The Expand line-handler
process is sending Probe messages to the remote Expand line-handler process to
verify that it is operational.
Queries test the connection to the associate device and do not go all the way
through to the remote line handler.
Disc
indicates the number of disconnect packets from the network service provided by
the network access method (NAM) process. Used for X25 and SNAX, disconnect
packets are sent to AssociateDev when the line is going inactive. You can set X.25
and SNAX lines to go inactive after a specified period with no in/out traffic. The line
remains up, but the underlying protocol is disconnected (this saves money on the
line).
Unbind
indicates the number of line-handler unbinds from an associate device (such as
$ZZFOX, $ZZSCL, or $X25AM). The line handler unbinds with the associate
device when it aborts.
Data
indicates the number of data frames sent. Normal FOX and ServerNet traffic are
not counted here because normal data traffic by-passes the line handler for these
processes.