Expand Configuration and Management Manual (G06.24+)

Subsystem Control Facility (SCF) Commands
Expand Configuration and Management Manual—523347-008
15-102
STATUS LINE Command
INACTIVE
indicates that the Expand line-handler process is inactive. It is either waiting for
data to send or is waiting for an active connect from the other side.
LISTEN
indicates that the Expand-over-ATM line-handler process is waiting for
switched virtual circuit (SVC) connection establishment from the remote
system. This state applies to Expand-over-ATM line-handler processes that
use SVC connections only.
PASSIVE
indicates that the Expand line-handler process is waiting for the remote
(destination) Expand line-handler process to initiate a connection.
QUERY
indicates that the Expand line-handler process is connected to the remote
(destination) Expand line-handler process, but no data has been received
within the inactivity interval (SCF TIMERPROBE attribute). The Expand line-
handler process is sending Probe messages to the remote Expand line-handler
process to verify that it is operational.
RECONNECTING
indicates that the Expand line-handler process received data while it was
inactive, sent an active connect, and is waiting for a reply.
REPASSIVE
indicates that the Expand line-handler process received data while it was
inactive, sent an passive connect, and is waiting for a reply.
SETOPT_CALLING
an internal state that should not persist. This state applies to Expand-over-ATM
line-handler processes only.
SETOPT_LISTEN
an internal state that should not persist. This state applies to Expand-over-ATM
line-handler processes only.
SOCKET_REUSE
an internal state that should not persist. This state applies to Expand-over-IP
line-handler processes only.