Expand Configuration and Management Manual (G06.24+)

Subsystem Control Facility (SCF) Commands
Expand Configuration and Management Manual523347-008
15-104
Considerations
Refer to the Operator Messages Manual for cause, effect, and recovery information for
the event numbers generated by the Expand subsystem.
Considerations
You can display the status information for several lines with a single STATUS LINE
command by specifying multiple LINE objects using parentheses as follows:
LINE ( line-name , line-name [ , line-name ] ... )
Examples
The following SCF command summarizes the status on line $LINE1:
-> STATUS LINE $LINE1
The following SCF command gives a detailed display of the status on path $LINE1:
-> STATUS LINE $LINE1, DETAIL
The following SCF command summarizes the status on paths $LINE2 and $LINE3:
-> STATUS PATH ($LINE2,$LINE3)
ATM subsystem unavailable 19
PVC unavailable, error nnn 20
SVC unavailable, error nnn 21
Associate NAM process unavailable 23
NAM process error nnn 24
NAM process timeout 25
NAM service down 26
ATM LIF error, error nnn 28
ATM LIF not found 29
ATM LIF is stopped 30
ATM LIF access state is down 31
ATM LIF inaccessible 32
Table 15-7. Messages and Corresponding Event Numbers (page 2 of 2)
Message Event Number