Expand Configuration and Management Manual (G06.24+)

Expand Modifiers
Expand Configuration and Management Manual523347-008
17-3
Required Modifiers
CALLTYPE_ATMSAP Specifies that an ATM protocol direct service access point
(ATMSAP) connection will be used.
Required by: Expand-over-ATM line-handler processes that run
through the SLSA subsystem.
Default: PVC (CALLTYPE_PVC modifier) is the default
connection type.
CALLTYPE_PVC Specifies that a permanent virtual circuit (PVC) connection will
be used.
Required by: Expand-over-ATM line-handler processes.
Default: PVC is the default connection type.
CALLTYPE_SVC Specifies that a switched virtual circuit (SVC) connection will be
used.
Required by: Expand-over-ATM line-handler processes.
Default: PVC (CALLTYPE_PVC modifier) is the default
connection type.
DESTATMADDR Specifies the Asynchronous Transfer Mode (ATM) address
configured for the ATM line used by the Expand-over-ATM line-
handler process at the remote system.
Required by: Expand-over-ATM line-handler processes that use
switched virtual circuit (SVC) connections.
Default: 20-byte null address.
DESTIPADDR Specifies the Internet Protocol (IP) address used by a remote
(destination) Expand-over-IP line-handler process.
Required by: Expand-over-IP line-handler processes if IPVER
is IPv4.
Default: 0.0.0.0.
DESTIPPORT Specifies the port number used by a remote (destination)
Expand-over-IP line-handler process.
Required by: Expand-over-IP line-handler processes if IPVER
is IPv4.
Default: 1024.
NEXTSYS Specifies the number of the system connected to the other end
of the line.
Required by: All types of Expand line-handler processes.
Default: 255.*
Table 17-1. Required Modifiers (page 2 of 3)
Modifier Description