Expand Configuration and Management Manual (G06.24+)

Expand Modifiers
Expand Configuration and Management Manual—523347-008
17-6
ASSOCIATESUBDEV #n
ASSOCIATESUBDEV #n
Default: No default for Expand-over-NAM line-handler processes
#IP for Expand-over-ATM line-handler processes
Units: Not applicable
Range: Not applicable
This modifier is required for Expand-over-NAM and Expand-over-ATM line-handler
processes only. n may specify the following:
•
The name of an X25AM subdevice to which the Expand-over-X.25 line-handler
process will bind.
•
The subdevice name of the SNAX/APN logical unit (LU) used by the Expand-over-
SNA line-handler process.
•
The name of the Asynchronous Transfer Mode (ATM) service access point (SAP)
used by the Expand-over-ATM line-handler process. The only currently supported
SAP is #IP.
ATMSEL n
Default: %H80
Units: Not applicable
Range: 0 through %HFF
This modifier is applicable to Expand-over-ATM line-handler processes that use
switched virtual circuits (SVCs) only. It specifies a hexadecimal selector byte for the
ATM line used by the local Expand-over-ATM line-handler process. The selector byte is
used by the ATM subsystem to direct incoming call requests to the correct ATM
subsystem client. Selector bytes must be coordinated among ATM clients using the
same ATM line. The selector byte is the last (rightmost) byte in an ATM address.
CALLTYPE_PVC/CALLTYPE_SVC/CALLTYPE_ATMSAP
Default: CALLTYPE_PVC
Units: Not applicable
Range: Not applicable
These modifiers are applicable to Expand-over-ATM line-handler processes only. The
CALLTYPE_PVC modifier indicates that a permanent virtual circuit (PVC) connection
will be used. The CALLTYPE_SVC modifier indicates that a switched virtual circuit
(SVC) connection will be used. The CALLTYPE_ATMSAP modifier indicates that the
ATMSAP connection through the SLSA subsystem will be used.