Expand Configuration and Management Manual (G06.24+)

Expand Modifiers
Expand Configuration and Management Manual—523347-008
17-10
DESTIPPORT n
DESTIPPORT n
Default: 1024
Units: Not applicable
Range: 0 through 65534
This modifier is applicable to Expand-over-IP line-handler processes only. This modifier
specifies the port number used by the remote (destination) Expand-over-IP line-
handler process. It is the port number specified in the remote line-handler process’
SRCIPPORT modifier. Port numbers are explained in the TCP/IP Configuration and
Management Manual.
DOWNIFBADQUALITY ON/ DOWNIFBADQUALITY OFF
Default: OFF
Units: Not applicable
Range: Not applicable
If set ON and the QUALITYTIMER timer expires, an EMS message is generated and
the line is aborted (see the QUALITYTIMER n and QUALITYTHRESHOLD n
parameters). If set OFF and the QUALITYTIMER timer expires, an EMS message is
generated and the line is not aborted.
This modifier is applicable to both single-line and multi-line IP, ATM, satellite, and
SWAN line-handler processes.
EXTMEMSIZE n
Default: 2048 kbytes (2 megabytes)
Units: kbytes
Range: 0 through 32767 kbytes (32 megabytes)
This modifier allows you to specify the base size of extended memory for Expand’s
internal buffer pool.
FLAGFILL_OFF/ FLAGFILL_ON
Default: FLAGFILL_ON
Units: Not applicable
Range: ON or OFF
These Layer 2 modifiers are applicable to direct-connect and satellite-connect Expand
line-handler processes only. The FLAGFILL_ON modifier causes a specific bit pattern
called FLAG to be set during the idle period for a line. You can use the FLAGFILL_OFF
modifier to cause bit-synchronous controllers to keep an idle line in the MARK HOLD
instead of the IDLE FLAGS state. Some modems and data circuit-terminating
equipment (DCE) require the idle line state to be configured with the FLAGFILL_ON
modifier.