Expand Configuration and Management Manual (G06.24+)

Expand Modifiers
Expand Configuration and Management Manual—523347-008
17-21
QUALITYTHRESHOLD n
QUALITYTHRESHOLD n
Default: 0
Units: Integers
Range: 0 through 99
If the line reports quality lower than this percentage value, a timer is started. See also
DOWNIFBADQUALITY ON/ DOWNIFBADQUALITY OFF and QUALITYTIMER n.
This modifier is applicable to both single-line and multi-line IP, ATM, satellite, and
SWAN line-handler processes.
QUALITYTIMER n
Default: 0
Units: hh:mm:ss
Range: 0 through 12 hours
This modifier specifies the time interval to wait after the line quality drops below the
threshold value specified in the QUALITYTHRESHOLD before taking the action
specified in the parameter DOWNIFBADQUALITY. See also QUALITYTHRESHOLD n
and DOWNIFBADQUALITY ON/ DOWNIFBADQUALITY OFF.
This modifier is applicable to both single-line and multi-line IP, ATM, satellite, and
SWAN line-handler processes.
RETRYPROBE n
Default: 19 for IP and ATM lines
10 for Expand-over-FOX and Expand-over-ServerNet lines
20 for Expand-over-NAM lines
Units: seconds
Range: 1 through 255
This modifier specifies the number of times the Expand-over-NAM, Expand-over-
ServerNet, or Expand-over-FOX line-handler process will retry its probe of the network
access method (NAM), or how many times the Expand-over-IP or Expand-over-ATM
line-handler process will retry the probe of the remote Expand-over-IP or Expand-over-
ATM line-handler process before declaring the network unavailable. A value of 0
indicates that timeouts are ignored and the connect state is maintained. See also
TIMERPROBE n and TIMERRECONNECT n.