Expand Configuration and Management Manual (G06.24+)

Expand Configuration and Management Manual—523347-008
1-1
1 Configuration Quick Start
This section provides the basic information required to enable you to quickly and easily
define and start an Expand line-handler process. This procedure requires that you use
the default values provided by the Expand subsystem for most configuration modifiers.
If you want a customized configuration, or if you want to change your configuration,
you must refer to the sections provided in Part II, Configuring the Expand Subsystem.
Task Summary
Configuring and starting an Expand line-handler process involves the following tasks:
•
Task 1: Configure and Start $NCP on page 1-2
•
Task 2: Start the Expand Manager Process on page 1-2
•
Task 3: Add the Expand Line-Handler Profile(s) on page 1-4
•
Task 4: Add the Expand Line-Handler Process on page 1-6
•
Task 5: Start the Expand Line-Handler Process on page 1-17
Assumptions
At the beginning of this procedure, the NonStop S-series server is assumed to be in
the following state:
•
The default software configuration provided by HP manufacturing is running.
•
The initial OSM or TSM configuration is complete.
•
The ServerNet LAN Systems Access (SLSA) subsystem has been configured and
started and an Ethernet 4 ServerNet adapter (E4SA), Fast Ethernet ServerNet
adapter (FESA), Gigabit Ethernet ServerNet adapter (GESA), or Gigabit Ethernet
4-port ServerNet adapter (G4SA) has been installed and started.
•
A NonStop TCP/IP process and Ethernet SUBNET have been created and started.
•
The WAN manager process ($ZZWAN) has been created and started.
•
The WAN subsystem Concentrator Manager (ConMgr), WANBoot, TFTP server,
and the SNMP trap multiplexer processes have been created and started.
•
The ServerNet wide area network (SWAN) concentrator has been installed,
configured, and started and has an available WAN line.