Expand Configuration and Management Manual (G06.24+)

Managing the Network
Expand Configuration and Management Manual—523347-008
19-19
Reconfiguring the Network
Reconfiguring the Network
Network reconfiguration tasks include the following:
•
Adding and Deleting Expand Line-Handler Processes
•
Adding and Deleting $NCP
•
Changing $NCP Modifiers
•
Changing Expand Line-Handler Process Modifiers
•
Changing Profiles
•
Adding Nodes to the Network
•
Removing Nodes From the Network
•
Changing System Names and Numbers
Adding and Deleting Expand Line-Handler Processes
The SCF interface to the WAN subsystem provides commands to add and delete
Expand line-handler processes from your system configuration. You use the WAN
subsystem SCF ADD DEVICE command to add and the SCF DELETE DEVICE
command to delete an Expand line-handler process.
Adding and Deleting $NCP
The SCF interface to the WAN subsystem provides commands to add and delete
$NCP from your system configuration. You use the WAN subsystem SCF ADD
DEVICE command to add and the SCF DELETE DEVICE command to delete $NCP.
Changing $NCP Modifiers
You can use the WAN subsystem SCF ALTER DEVICE command to change any
$NCP modifier value in the device record for $NCP.
You can use the Expand subsystem SCF ALTER PROCESS command to change the
following $NCP modifier values:
The Expand subsystem SCF ALTER PROCESS command can also be used to enable
or disable the reporting of event messages 43, 46, 48, and 49; this cannot be done
using the WAN subsystem SCF ALTER DEVICE command.
Note. Configuration changes made with the SCF interface to the WAN subsystem are
permanent (they remain in effect after system loads and processor reloads); changes made
with the SCF interface to the Expand subsystem are temporary (they do not remain in effect
after system loads and processor reloads).
ABORTTIMER CONNECTTIME
MAXCONNECTS MAXTIMEOUTS
NETWORKDIAMETER