Expand Configuration and Management Manual (G06.24+)

Configuration Quick Start

Expand Configuration and Management Manual—523347-008

1-4

Task 3: Add the Expand Line-Handler Profile(s)

HP provides profiles, which contain modifiers and default modifier values, for each type

of Expand line-handler process. You can use these profiles to create profiles for your

Expand line-handler processes. To add a profile for an Expand line handler, perform

the following steps:

1. If you want add a single-line Expand line-handler process, perform the following

steps. If you want to add a multi-line path, got to Step 2.

a. Add a profile to the WAN subsystem for the type of Expand line-handler

process that you want to configure.

-> ADD PROFILE $ZZWAN.#name, &

FILE $SYSTEM.SYS00.profile_name

where name is the name you want to assign to the profile and profile_name

is the name of a profile listed in Table 1-1.

2. If you want to add a multi-line path, perform the following steps:

a. Add a profile to the WAN subsystem for the path-logical device using the

PEXPPATH profile:

-> ADD PROFILE $ZZWAN.#name, FILE $SYSTEM.SYS00.PEXPPATH

where name is the name you want to assign to the profile.

b. Add a profile for each type of line in the multi-line path:

-> ADD PROFILE $ZZWAN.#name2, &

FILE $SYSTEM.SYS00.profile_name

where name2 is the name you want to assign to the profile and

profile_name is the name of a profile listed in Table 1-2,

Note. To add a Expand line-handler process that is part of a multi-CPU path, perform either

Step 1 or Step 2 as described below.

Table 1-1. Profiles for Single-Line Expand Line-Handler Processes

Profile Name Type of Single-Line Expand Line-Handler Process

PEXQSSWN Direct-connect

PEXQSSAT Satellite-connect

PEXQSNAM Expand-over-NAM

PEXQSIP Expand-over-IP

PEXQSATM Expand-over-ATM

PEXPSSN Expand-over-ServerNet

PEXQSFX Expand-over-FOX