Expand Configuration and Management Manual (G06.24+)

Troubleshooting
Expand Configuration and Management Manual—523347-008
21-7
SCF Commands
The SCF INFO PROCESS $NCP LINESET command is useful for displaying the
status of a selected path and the lines in that path. The SCF INFO PROCESS $NCP,
LINESET command also displays the current file-system error. Example 21-4 shows an
example of an SCF INFO PROCESS $NCP, LINESET display.
Table 21-4 lists and describes the file-system error numbers that are most commonly
reported by the SCF INFO PROCESS $NCP, LINESET command.
Example 21-4. SCF INFO PROCESS $NCP, LINESET Display
-> INFO PROCESS $NCP, LINESET
EXPAND Info PROCESS $NCP , LINESET
LINESETS AT \NODEA (117) #LINESETS=7 TIME: FEB 24,2003 13:55:04
LINESET NEIGHBOR LDEV TF PID LINE LDEV STATUS FileErr#
1 S \NODEB (082) 122 1 ( 1, 334)
1 122 READY
2 S \NODEB (082) 123 1 ( 0, 333)
1 123 READY
3 S \NODEB (082) 121 1 ( 0, 332)
1 121 READY
4 \NODEB (082) 131 -- -- -----
1 131 NOT READY (066)
5 \NODEB (082) 125 3 ( 2, 271)
1 125 READY
6 \NODEF (247) 132 -- -- -----
1 132 NOT READY (066)
7 \NODEF (247) 175 -- -- -----
1 212 NOT READY (066)
2 254 NOT READY (066)
3 256 NOT READY (066)
4 259 NOT READY (066)
Table 21-4. Common File-System Errors (page1of2)
Error Cause Recovery
66 This error indicates that the line
was aborted or was never
started.
If the communications line interface processor
(CLIP) remains STOPPED, use the following
SCF commands:
ABORT LINE $device_name
START LINE $device_name
124 This error can occur when you
attempt to start a line. The
causes of this error differ
depending on the type of line.
If error 124 persists, there may
be a hardware problem.
The recovery depends on the cause of the
error. If the error does not persist, no action is
necessary. However, if the error does persist, a
hardware error may be indicated and you
should contact your HP representative.
Note. Detailed information about network-related file-system errors is provided in the Operator Messages
Manual
.