Expand Configuration and Management Manual (G06.24+)

Troubleshooting
Expand Configuration and Management Manual—523347-008
21-23
Expand-Over-IP Problems
shows an SCF INFO LINE command display. (The relevant fields are shown in
boldface type.)
Resolving Expand-Over-IP Wait Problems
If the SCF STATUS LINE command with the DETAIL option displays WAIT in the
Detailed State field, check the Detailed Info field for more detailed error information.
Table 21-12 describes the messages that might be displayed in the Detailed Info field.
Example 21-9. SCF INFO LINE, DETAIL Command (Expand-Over-IP)
-> INFO LINE $IPTAH0, DETAIL
EXPAND Detailed Info LINE $IPTAH0 (LDEV 175)
L2Protocol Net^Ip TimeFactor...... 3 *SpeedK........ NOT_SET
Framesize....... 132 -Rsize........... 3 -Speed........
*LinePriority.... 1 StartUp......... OFF Delay......... 0:00:00.10
*DownIfBadQuality OFF *QualityThreshold 96 *QualityTimer.. 0:01:00.00
*Txwindow........ 7 *Maxreconnects... 0 *AfterMaxRetries PASSIVE
*Timerreconnect 0:00:30.00 *Retryprobe...... 19 *Timerprobe.... 0:00:01.00
*Associatedev.... $ZTC02 *LineTf.......... 0 *Timerinactivity 0:00:00.00
*IPVer IPV4
*DestIpAddr 16.107.189.66 *DestIpPort...... 5744
*SrcIpAddr 16.107.188.54 *SrcIpPort....... 5744
*V6DestIpAddr ::
*V6SrcIpAddr ::
Table 21-12. Messages Displayed in the Detailed Info Field (Expand-Over-
IP) (page 1 of 2)
Message Description
Shared memory system unavailable The QIO subsystem is not available. Check the
state of the QIO subsystem. The line will become
ready when the QIO subsystem becomes available.
Ownership error The Expand-over-IP line-handler process is unable
to switch processors. An ownership error occurs
when the NonStop TCP/IP process associated with
the Expand-over-IP line-handler process indicates
that it is no longer the primary process, but the line-
handler process is unable to switch processors
because other lines in the multi-line path are active.
(An Expand-over-IP line-handler process and the
NonStop TCP/IP process with which it is associated
must always reside in the same processor.) The
Expand-over-IP line-handler process will not be
able to switch processors until all other lines in the
path are inactive (that is, they do not have socket
connections).