Expand Configuration and Management Manual (G06.24+)

SCF Error Messages

Expand Configuration and Management Manual—523347-008

A-4

Expand Error 00013

Cause. The system number specified in the SCF command is not recognized by the

network control process ($NCP).

Effect. The SCF command was not executed.

Recovery. Re-enter the command making sure to use the correct system number.

Expand Error 00014

Cause. All paths to the specified system are down.

Effect. Your local system cannot communicate with the specified system.

Recovery. Re-enter the command in a few minutes. If you still cannot communicate

with the specified system, contact the system manager.

Expand Error 00015

Cause. The local system was just loaded. Its network routing table (NRT) is not yet

updated.

Effect. The local system cannot communicate with any other systems.

Recovery. Re-enter the command in a few minutes.

Expand Error 00016

Cause. The SCF command was rejected by the Expand manager process ($ZEXP).

This error may be caused by mismatched product versions between $ZEXP and the

Expand line-handler process or the network control process ($NCP).

Effect. The SCF command was not executed.

Recovery. Check the product versions of $ZEXP, the Expand line-handler process,

and $NCP. Install the correct product versions if required, then re-enter the command.

EXPAND 00013 The SYSTEM system-number is not defined.

EXPAND 00014 All paths to the SYSTEM system-number are

down.

EXPAND 00015 No known systems.

EXPAND 00016 Negative EXPAND manager response.