Expand Configuration and Management Manual (G06.24+)

Expand and WAN SCF Comparison
Expand Configuration and Management Manual—523347-008
C-4
Command Comparison
PRIMARY PRIMARY Expand SCF:
•
Use the PRIMARY PROCESS command to
cause the backup processor to become the
primary processor and the primary processor
to become the backup processor for a
selected Expand line-handler process or for
the network control process ($NCP).
WAN SCF:
•
Use the PRIMARY SUBSYS command to
change the preferred processor of the WAN
manager process ($ZZWAN).
PROBE Use the Expand subsystem PROBE PROCESS
command to display the current paths to one or
more, or all, of the remote nodes within a
network, from a specified node in the network.
START START Expand SCF:
•
Use the START LINE command to initiate the
operation of a selected Expand line.
•
Use the START PATH command to start all
the lines in a selected multi-line path.
WAN SCF:
•
Use the START DEVICE command to start a
selected Expand line-handler process or the
network control process ($NCP).
Note: You must use the START DEVICE command to start
an Expand line-handler process before using the Expand
subsystem START LINE or START PATH command.
STATS
•
Use the Expand subsystem STATS LINE
command to display Layer 2 statistical
information for a selected Expand line.
•
Use the STATS PATH commands to display
Layer 3 and Layer 4 statistical information for
a selected Expand path.
•
Use the STATS PROCESS command to
display statistical information about the
network control process ($NCP).
Table C-1. Expand and WAN SCF Command Comparison (page 4 of 6)
Expand
Subsystem SCF
Command
WAN
Subsystem SCF
Command Command Function