Expand Configuration and Management Manual (G06.24+)

Expand and WAN SCF Comparison
Expand Configuration and Management Manual—523347-008
C-5
Command Comparison
STATUS STATUS Expand SCF:
•
Use the STATUS LINE command to display
the dynamic state, primary process ID
(PPID), backup process ID (BPID), and other
information about a selected Expand line.
•
Use the STATUS PATH command to display
the dynamic state, primary process ID
(PPID), backup process ID (BPID), and
number of lines in a selected Expand path.
•
Use the DETAIL option with either STATUS
command to display additional information.
WAN SCF:
•
Use the STATUS DEVICE command to
display the dynamic state and logical device
(LDEV) number of a selected Expand line-
handler process or the network control
process ($NCP).
STOP STOP Expand SCF:
•
Use the STOP LINE command to terminate
the activity of a selected Expand line.
•
Use the STOP PATH command to terminate
the activity of all lines in multi-line path.
Note: You should use the STOP LINE or STOP PATH
command before using the WAN subsystem STOP DEVICE
command.
WAN SCF:
•
Use the STOP DEVICE command to
terminate the activity of a selected Expand
line-handler process or the network control
process ($NCP).
TRACE Use the Expand subsystem TRACE command to
request the capture of target-defined data items,
alter trace parameters, and end tracing.
Table C-1. Expand and WAN SCF Command Comparison (page 5 of 6)
Expand
Subsystem SCF
Command
WAN
Subsystem SCF
Command Command Function