Expand Configuration and Management Manual (G06.24+)

Expand and WAN SCF Comparison

Expand Configuration and Management Manual—523347-008

C-7

ALTER Command Comparison

You can use the SCF interface to the WAN subsystem to permanently change the

value of any Expand modifier used by an Expand line-handler process or the network

control process ($NCP). Expand modifiers are described in Section 17, Expand

Modifiers.

Modifier-to-Attribute Comparison

Most—but not all—Expand modifiers have corresponding attribute names in Expand

SCF. For example, the L4TIMEOUT modifier corresponds to the L4TIMEOUT Expand

SCF attribute.You can use the SCF interface to the Expand subsystem to temporarily

change modifiers that have corresponding SCF attribute names.

Profile Modifiers Only

Certain Expand modifiers do not have corresponding attribute names in Expand SCF

and therefore can be changed only by using the SCF interface to the WAN subsystem.

These modifiers are as follows:

SCF Attributes Only

Certain Expand SCF attributes do not correspond to Expand modifiers and therefore

can be changed only by using the SCF interface to the Expand subsystem. These

attributes are as follows:

Note. Permanent changes remain across system loads; temporary changes do not remain

across system loads.

ALGORITHM AUTOMATICMAPTIMER

EXTMEMSIZE FRAMESIZE

INTERFACE_RS232 INTERFACE_RS422

STARTUP_OFF STARTUP_ON

CLBDWNLOADRETRIES TIMERINACTIVITY

CLBDWNLOADTIMER TIMERPROBE

CLBIDLETIMER TIMERRECONNECT

DSRTIMER MSG 43 ON|OFF

IDLETIMEOUT MSG 46 ON|OFF

RETRYPROBE MSG 48 ON|OFF

TIMERBIND MSG 49 ON|OFF