Expand Configuration and Management Manual (G06.24+)

Configuration Quick Start
Expand Configuration and Management Manual—523347-008
1-12
Creating a Single-Line Expand Line-Handler
Process
Expand-Over-ATM Line-Handler Process
The Expand-over-ATM line-handler process must be associated with an Asynchronous
Transfer Mode (ATM) line. It can use a switched virtual circuit (SVC) or a permanent
virtual circuit (PVC) connection.
Expand-over-ATM lines can also use the ATMSAP connection option through the
SLSA subsystem.
Configuring the ATM subsystem is not described here; you can find information about
this topic in Section 9, Configuring Expand-Over-ATM Lines.
To create an Expand-over-ATM line-handler process, perform the following step:
tcp6sam_process The name of the NonStop TCP/IPv6 TCP6SAM process you want to
associate with the Expand-over-IP line-handler process. The
TCP6SAM process does not need to be configured in the same
processor pair as the Expand-over-IP line-handler process but there
must be a NonStop TCP/IPv6 subsystem monitor process
($ZZTCP.#ZPTMn, where n is the processor number) in the
processors that contain the Expand-over-IP line-handler process
pair. If you use NonStop TCP/IPv6 in INET (IPv4) mode, it behaves
similarly to Parallel Library TCP/IP and the additional parameters for
IPv6, IPVER_IPV6, V6SRCIPADDR, and V6DESTIPADDR are not
needed. DESTIPADDR is required for INET operations, however.
NonStop TCP/IPv6 has a feature not present in Parallel Library
TCP/IP called logical network partitioning (LNP) that affects
configuration. See Internet Protocol (IP) Networks
on page 3-4 for
more information about this feature.
dipaddr The IP address used by the remote (destination) Expand-over-IP
line-handler process. The address must be specified by number.
dipport The UDP port number used by the remote (destination) Expand-
over-IP line-handler process.
sipaddr The IP address used by the NonStop TCP/IP process specified by
tcpip_process. The address must be specified by number.
sipport The UDP port number used by this Expand-over-IP line-handler
process. Valid values are in the range 0 through 65536. Do not use
well-known ports in the range 0 through 1023.
ipv6srcaddress The IP address used by the NonStop TCP/IP process specified by
the tcpipV6_process. The address must be specified by
number.
ipv6destaddress The IP address used by the NonStop TCP/IP process specified by
the tcpipV6_process. The address must be specified by
number.
Table 1-4. SCF ADD DEVICE Syntax: Expand-Over-IP (page 2 of 2)
Parameter Description