Expand Configuration and Management Manual (G06.24+)

Configuration Quick Start
Expand Configuration and Management Manual—523347-008
1-17
Where to Find More Information About This Task
•
Include the MULTI modifier as follows:
MULTI $path_name
where path_name is the name of the path-logical device you created in
Step 1.
The following rules apply when creating line-logical devices:
•
You can configure a maximum of eight lines in a multi-line path.
•
The path-logical device and all of the line-logical devices with which it is associated
must be configured in the same processor pair.
The following is an example of an SCF ADD DEVICE command that adds a line-logical
device for an Expand-over SNA line:
-> ADD DEVICE $ZZWAN.#LINE2, PROFILE MLHSNA,&
IOPOBJECT $SYSTEM.SYS01.LHOBJ, CPU 0, ALTCPU 1,&
TYPE (63,2), RSIZE 0, PATHTF 3, ASSOCIATEDEV $SNA1,&
ASSOCIATESUBDEV #SNAM, MULTI $PATH
Where to Find More Information About This Task
Section 7, Configuring Direct-Connect and Satellite-Connect Lines
Section 8, Configuring Expand-Over-IP Lines
Section 9, Configuring Expand-Over-ATM Lines
Section 10, Configuring Expand-Over-X.25 Lines
Section 11, Configuring Expand-Over-SNA Lines
Section 12, Configuring Expand-Over-ServerNet Lines
Section 13, Configuring Expand-Over-FOX Lines
Section 14, Configuring Multi-Line Paths
Task 5: Start the Expand Line-Handler Process
Start the single-line Expand line-handler process or path-logical device. When you use
this command to start a path-logical device, the line-logical devices associated with the
path are also started.
-> START DEVICE $ZZWAN.#device_name
where device_name is the device name of the Expand line-handler process or path-
logical device.