Expand Management Programming Manual

MANAGEMENT PROGRAMMING FOR THE EXPAND SUBSYSTEM
Commands an Application Can Issue
Table 2-1. EXPAND Programmatic Commands
ABORT Terminates the operation of lines or paths
immediately.
ALTER Changes the values of attributes of lines,
paths, or line-handler processes.
GETVERSION Returns the server version of the EXPAND
manager process.
INFO Returns the current values of the attributes of
lines, paths, or line-handler processes, or
returns network map and/or path map informa-
tion about one system as seen from another
specified system.
LOAD Causes the Communications Line Interface
Processor (CLIP) to be downloaded.
PROBE Returns information about the current paths
from other systems to a selected system.
RESET Causes the CLIP to be placed in the boot state.
RESETSTATS Returns statistical information about lines or
paths and then clears the statistics counters.
START Initiates the operation of lines or paths.
STATISTICS Returns statistical information about lines,
paths, communication between systems, or
network traffic through a given system.
STATUS Returns information about the current state of
lines or paths.
STOP Terminates the operation of lines or paths if
they have no connections to other systems.
SWITCH Switches line-handler processes between
processors or Communications Interface Unit
(CIU) paths.
TRACE Initiates, modifies, or terminates trace mode
on lines, paths, the EXPAND manager process,
or the NCP.
2-4