Expand Management Programming Manual

MANAGEMENT PROGRAMMING FOR THE EXPAND SUBSYSTEM
Commands an Application Can Issue
Tables 2-2, 2-3, 2-4, 2-5, and 2-6 show the correspondence
between the interactive commands you use to control and inquire
about the EXPAND subsystem and the corresponding programmatic
commands you send to the EXPAND subsystem. Each table lists
the programmatic commands corresponding to the commands (those
applicable to EXPAND) in one particular interactive interface:
Table 2-2 for the Subsystem Control Facility (SCF), Table 2-3
for the Communications Management Interface (CMI), Table 2-4 for
NETMON, Table 2-5 for CUP, and Table 2-6 for PUP.
To make the contrast between the two kinds of commands clear, the
tables give the programmatic command and object names in the full
form you must use in programs. Later in this manual, in text and
in the headings for the command descriptions, the commands and
object types appear in a shortened form (without the ZCOM-CMD-
and ZCOM-OBJ- prefixes).
Note that in some cases, the correspondence between interactive
and programmatic commands is not exactly one-to-one. When
commands listed in the tables do not correspond exactly, the
programmatic interface usually provides more functionality than
the interactive interface.
2-5