Expand Management Programming Manual

EVENT MANAGEMENT
90: ZEXP-EVT-NET-BAD-SYSGEN
Probable Cause
The EXPAND subsystem detected a missing, incorrect, or inconsis-
tent SYSGEN parameter, as described by the value of the token
ZEXP-TKN-BAD-SYSGEN-CAUSE. If the error pertains to the configu-
ration of a line handler, the line handler stops and cannot be
used. Otherwise, the indicated line or path cannot be used.
Recommended Action
Specific recovery information for some of the possible values
of ZEXP-TKN-BAD-SYSGEN-CAUSE is given below. Most cases call
for correcting the missing, incorrect, or inconsistent parameter
associated with the indicated line or path in the SYSGEN
configuration file. If you change the configuration file, you
must then run INSTALL again.
1 Remove the MULTI parameter or change the subtype to 2
or 6.
2 Specify eight or fewer lines for the indicated path.
3 Change the line subtype to 0, 1, 2, 3, 5, or 6.
4 Check the MULTI parameters and the device subtypes for
the lines. Correct any instance where 6100 CSS lines
and lines other than 6100 CSS are mixed on the same
path.
5 For single-line devices (subtypes 0 and 5), supply the
NEXTSYS parameter to the line by using SCF, CMI, or
CUP. Then bring up the line using SCF, CMI, or PUP.
You do not have to run INSTALL again; however, you
should correct the SYSGEN configuration file before the
next time you run INSTALL.
6 Correct the configuration file by including the MULTI
parameter for all lines that are meant to be part of
the logical path.
7 Make sure that FOX and X.25 lines are not combined in a
multiline path.
8 If the 6100 CSS lines have two CIUs, make sure that
all the lines use the same CIU as the primary CIU.
Otherwise, make sure that the lines use the same
CSS6105 controller.
8-50