Fast Ethernet Adapter Installation and Support Guide

What’s New in This Guide
Fast Ethernet Adapter Installation and Support Guide—425685-003
viii
Manual Information
•
Who Should Use This Guide has this new note:
•
Chapters 2, 3, and 4 and Appendix B have this new note:
•
Replaced all references to Total Information Manager (TIM) with the NonStop
Technical Library (NTL).
•
Updated the HP Publications email address for customer feedback.
•
Updated the part number for the HP ESD kit.
Changes to the 425685-002 Version
•
This publication has been updated to reflect new product names:
•
Since product names are changing over time, this publication might contain
both HP and Compaq product names.
•
Product names in graphic representations are consistent with the current
product interface.
•
Where applicable, added mention of the manual TCP/IPv6 Configuration and
Management Manual.
•
In Section 1, Introduction to the Fast Ethernet ServerNet Adapter (FESA), added
mention of NonStop TCP/IPv6.
•
In Section 2, Installing a New FESA, added mention of NonStop TCP/IPv6 and
Ethernet failover.
•
In Section 3, Replacing an FESA: added mention of NonStop TCP/IPv6 and
Ethernet failover; altered Example 3-2 to reflect NonStop TCP/IPv6.
•
In Section 4, Relocating an FESA, added mention of NonStop TCP/IPv6 and
Ethernet failover.
•
In Appendix B, Preparing an FESA for PMF or IOMF CRU Replacement, added
mention of guided replacement procedures.
•
Made various updates to Safety and Compliance and the glossary.
Note. This guide describes using TSM to perform FESA procedures. As of G06.22 and
later RVUs, the HP NonStop Open System Management (OSM) Interface replaces TSM
as the system management tool of choice for NonStop S-series servers and is required to
support new functionality in G06.22 and later RVUs. OSM provides the same functionality
as TSM while overcoming limitations of TSM. For instructions on using OSM or migrating
to OSM, refer to the OSM documentation for your RVU.
Note. As of G06.22 and later RVUs, the HP NonStop Open System Management (OSM)
Interface replaces TSM as the system management tool of choice for NonStop systems.
For instructions on using OSM or migrating to OSM, refer to the OSM documentation for
your RVU.