Fast Ethernet Adapter Installation and Support Guide

Relocating an FESA
Fast Ethernet Adapter Installation and Support Guide—425685-003
4-13
Stop the Communications Lines and SWAN
Concentrator Line Using the FESA
5. Stop the SWAN concentrator.
Use the SCF STOP ADAPTER command with the SUB ALL option. The SUB
ALL option stops the ADAPTER object and its subordinate objects.
STOP ADAPTER $ZZWAN.#adapter-name, SUB ALL
6. Verify that the SWAN concentrator is in the STOPPED state.
Use the SCF STATUS ADAPTER command:
STATUS ADAPTER $ZZWAN.#adapter-name
Example 4-15 shows the output of this command. Note that the ServerNet wide
area network (SWAN) concentrator is in the STOPPED state.
To Stop an Expand-over-IP Line:
The following describes how to stop an Expand-over-IP line:
1. Abort the Expand-over-IP line.
a. Use the SCF ABORT LINE command to stop a single line:
ABORT LINE $line-name
b. Use the SCF ABORT PATH command to stop all the lines in an Expand
multiline path:
ABORT PATH $path-name
2. Verify that the Expand-over-IP line is in the STOPPED state.
Example 4-14. SCF STATUS DEVICE Command
->STATUS DEVICE $ZZWAN.#LINE1
WAN Manager STATUS DEVICE for DEVICE \COWBOY.$ZZWAN.#LINE1
State :........ STOPPED
LDEV number.... 110
PPIN........... 2 ,13 BPIN......... 3 ,14
Example 4-15. SCF STATUS ADAPTER Command
->STATUS ADAPTER $ZZWAN.#S01
WAN Manager STATUS ADAPTER for ADAPTER \COWB0Y.$ZZWAN.#S01
State....... STOPPED
Number of clips. 3
Clip 1 status : CONFIGURED
Clip 2 status : CONFIGURED
Clip 3 status : CONFIGURED