Fast Ethernet Adapter Installation and Support Guide

Relocating an FESA
Fast Ethernet Adapter Installation and Support Guide—425685-003
4-17
Stop the FESA
Stop the FESA
To stop an FESA, perform the following:
1. Determine the name of the logical interface (LIF) associated with the FESA to be
relocated.
Use the SCF INFO LIF command:
INFO LIF $ZZLAN.*
Example 4-23 shows the output of this command. The logical interface (LIF)
name is shown in the Name column and the physical interface (PIF) name is
shown in the PIF column. The name of the Fast Ethernet ServerNet adapter
(FESA) CRU is the first part of the PIF name (for example, E0153).
The PIF name indicates the physical port on the FESA CRU. For example, the
PIF named E0153.0.A. identifies port ENET 0A on the FESA named E0153. In
this example, the LIF associated with the FESA CRU named E0153 is named
L018.
Example 4-22. SCF INFO ADAPTER Command
-> INFO ADAPTER $ZZLAN.E0153
SLSA Info ADAPTER
Name Group Module Slot Type
$ZZLAN.E0153 1 1 53 FESA
Note. If Fast Ethernet ServerNet adapters (FESA) are named using the HP Manufacturing
naming convention, you can easily identify the physical location of the FESA by its name as
follows:
$ZZLAN.Ecabid-slot
where cabid is the two-digit number that identifies the enclosure and slot is the actual
physical slot number in the enclosure. For example, the FESA named E0153 is located in
enclosure 01, slot 53. (See Manufacturing Naming Conventions
on page 1-9.)
Example 4-23. SCF INFO LIF Command
->INFO LIF $ZZLAN.*
SLSA Info LIF
Name PIF MAC Address Type
$ZZLAN.L018 E0153.0.A 08:00:8E:00:5C:85 Ethernet